iZ Technology RADAR - Page 195

www.izcorp.com • 1.800.776.1356
REFERENCE
R
ADAR 3.50
188
Shortcut keys:
Session Controller
KC-24 N/A
Used to name a selected project. The dialogue cursor
defaults to the project number field.
Used to renumber a project (1 – 999) quickly. This is
often required to give restored projects the same number
for RADARLink operation.
Sets the sample rate for the selected project.
This option can only be changed before
audio is recorded.
Sets the bit depth for the selected project. The available
bit depths are 16 and 24-bit PCM.
This option can only be changed before
audio is recorded.
Shortcut keys (sets format and rate):
Session Controller + (TC PREF)
KC-24 +
The TC FORMAT dialogue allows the selection of either
SMPTE or MTC as a timecode format. SMPTE is input
and output via the LTC connectors on the back panel.
MTC is input and output using the MIDI IN and OUT
connectors on the rear panel.
MAIN/PROJ MENU:
TC FORMAT
MAIN/PROJ MENU:
BIT RESOLUTION
MAIN/PROJ MENU:
SAMPLE RATE
MAIN/PROJ MENU:
RENUMBER PROJECT
MAIN/PROJ MENU:
NAME PROJECT