iZ Technology Corporation
This feature controls how new projects are to be
numbered. If FROM 1 is selected, RADAR will assign the
lowest available project number whenever a new project
is created. If FROM CUR is selected, then RADAR will
use the next available number starting at the current
project number.
Sets the sample rate for newly created projects. Valid
values range from 32kHz to 192 kHz, depending on the
I/O cards installed.
This preference determines the default bit-depth or bit
resolution for newly created projects.
This preference determines the default tc format, SMPTE
or MTC, for newly created projects.
This preference determines the default tc rate for newly
created projects.
All standard SMPTE/EBU formats are supported.
Sets the start time that will be automatically assigned to
new projects.
This allows a default undo level to be set for all new
projects.
This preference sets the wave-drawing noise floor for all
new projects.
These options are used to create and manage templates.
See OPERATIONS: PROJECT MANAGEMENT: PROJECT
TEMPLATES for more information.
Use this option to create a new project template.
Use this option to import a project template.
TEMPLATE MENU:
IMPORT TEMPLATE
TEMPLATE MENU:
MAKE TEMPLATE
PROJECT PREFS:
NEW PROJ NUMBER
MAIN/PROJ MENU:
TEMPLATE MENU
PROJECT PREFS:
DEF WAVE NS FLR
PROJECT PREFS:
DEF START TIME
PROJECT PREFS:
DEF UNDO LEVEL
PROJECT PREFS:
DEF TC RATE
PROJECT PREFS:
DEF TC FORMAT
PROJECT PREFS:
DEF BIT RES
PROJECT PREFS:
DEF SAMPLE RATE
To Next Page
Loading...
