iZ Technology Corporation
At the FILE FORMAT: dialogue, use the and keys to select WAV, BWAV, or CDAUDIO
(
CDAUDIO will only be available if STEREO was selected in the previous step) and press the
key.
To set the default as
WAV or BWAV when exporting, change the FILE FORMAT preference.
This will bypass the prompt when files are exported.
To set the file format preference:
a. Use the
, the and keys, and the key to go to the MAIN MENU / FILE
MENU / FILE PREFS / EXPORT FORMAT
selection and press the key.
b. Use the
and keys to select either the MONO FORMAT or STEREO FORMAT.
c. At the
FILE FORMAT: prompt, use the and keys to select WAV or BWAV or
CDAUDIO (CDAUDIO will only be available if STEREO FORMAT was selected in the
previous step) and then press the
key. The factory default setting is ASK.
If selecting WAV or BWAV, skip to step 7.
If selecting CDAUDIO and the project sample rate and/or bit resolution is NOT 16 bit/44.1kHz, it
will prompt with a
REFORMAT QUALITY dialogue. Use the and keys to select Q1, Q2 or
Q3 and press the key.
To set the
REFORMAT QUALITY: preference:
a. Use the
, the and keys and the key to go to the MAIN MENU / FILE
MENU / FILE PREFS / REFORMAT QUALITY
selection and press the key.
b. Use the
and keys to select Q1, Q2 or Q3 and then press the key. The factory
default setting is
Q3.
Q3 represents the slowest speed but highest quality.
84
Rev. A
To Next Page
