iZ Technology Corporation
When RADAR has finished rebooting, the iZ logo will appear on the screen with the following
message below it:
INSTALL RADAR
VX.XX? ENTR/CNCL
To not proceed with the upgrade, press the key. Press the key and RADAR will
begin reading the software install file, and the message will change to:
INSTALLING RADAR
VX.XX DISK 1
Once the software is successfully installed RADAR will start up in the new version and all projects
will automatically be upgraded to the new software version format. This operation may take a few
seconds per project.
Power off RADAR and reboot to complete the setup of new drivers.
After you have finished using a USB drive, make sure you unmount it before unplugging it
from RADAR. You can access the MOUNT/UNMOUNT dialog via the DISK MENU or by
pressing + UNMNT on the Session Controller.
RADAR NETWORK CONTROL SOFTWARE FOR PC
The RNC (RADAR Network Control) program allows the control of one or more RADAR machines over
the Ethernet using a standard computer with Java Runtime Environment installed (version 1.4.2 or
higher). A 30 day trial version of the RNC program is located on the software install CD included with
RADAR. Please contact a local dealer or our sales department, izsales@izcorp.com or 1.800.776.1356, if
you would like to purchase the full version.
Some of the RADAR features included in RNC are:
RWD
FFWD
PLAY
STOP
RECORD
CUT
COPY
PASTE
ERASE
GOTO PROJECT
NEW PROJECT
NAME PROJECT
DELETE PROJECT
TRACK NAME
TRACK SOLO
TRACK MUTE/UNMUTE
TRACK ARM
AUTO INPUT
MARK IN/OUT/SYNC
MARK/EDIT/RECALL LOC
ENTER TIME
FILE MANAGEMENT BROWSE
FILE IMPORT
MOUNT/UNMOUNT
RADARLINK
SHUTDOWN
SET TIME/DATE
SYNC REFERENCE
TC PREFS
SYNC OFFSET
CHASE
I/O ROUTING
DIG IN FORMAT
DIG IN TRACKS
ERASE ALL DISKS
To Next Page
Loading...
