www.izcorp.com • 1.800.776.1356
For instructions on using the RNC software, please refer to the help files located within the RNC folder on
the software install CD.
If you are using a KC-24 connected to your computer to control RNC, the left-of-spacebar
key = FFWD and the right-of-spacebar key = STOP.
To enable RADAR Network Control software:
Configure the RADAR for networking using the INTERFACE PREFS within the NETWORK
PREFS of the PREFERENCES MENU. Refer to CONFIGURATION: NETWORKING earlier in this
section for detailed instructions.
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES MENU / NETWORK PREFS / NETWORK CONTROL and press the
key.
Use the key to move the cursor to ENABLED in the NETWORK CONTROL dialogue and
press the key.
The confirmation prompt NETWORK CONTROL SLAVE ID = X indicates that the RADAR can
now be controlled by using the slave id given.
To disable RADAR Network Control software:
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES MENU / NETWORK PREFS / NETWORK CONTROL and press the
key.
Use the key to move the cursor to DISABLED in the NETWORK CONTROL dialogue and
press the key.
A confirmation prompt NETWORK CONTROL SLAVE DISABLED indicates that RADAR will no
longer be controllable by RNC (RADAR Network Control).
To Next Page
Loading...
