iZ Technology Corporation
RADARII and older versions of RADAR software CANNOT restore backups within folders
on DVD-RAM, Blu-ray and SCSI disks. If these backups need to be restored on a
RADARII or RADAR24 running older software, they should be backed up to the <ROOT
DIRECTORY>.
<ROOT DIRECTORY> must be selected at the SELECT FOLDER: dialogue within the
BACKUP menu if using removable media (DVD-RAM or Blu-ray) and the backup size is
larger then one side of the chosen media.
At the BACKUP PROJ: dialogue, use the and keys to select ALL PROJECTS, CURRENT
PROJECT or SELECTED PROJS and press the key.
If the SELECTED PROJS option is chosen, select the individual project or projects to back up by
using the and keys and the and keys on the numeric keypad. Pressing the key
adds the selected project to the archiving list and places a + sign to the right of its name. It also
increments the number of selected projects in the upper right hand corner of the menu display.
Pressing the key removes the selected project from the archiving list and removes the + sign
to the right of its name. It also decrements the number of selected projects in the upper right hand
corner of the menu display.
When using either the SELECTED PROJS or ALL PROJECTS option, the way in which the
projects are organized within the backup must be chosen.
• Grouping archives by PROJECT means that each project will be backed up separately
and can therefore be restored separately.
• Grouping by SET means that all the projects selected will be backed up as a data set,
and must be restored as a set. Backup size may be reduced if audio is shared between
projects in the same group.
At the BACKUP GROUPING: dialogue, select PROJECT or SET and press the key.
When using the SET option a name must also be chosen for the backup. At the BACKUP NAME:
dialogue, use the keyboard to enter a new name in the name field or accept the default name and
press the key. Backups grouped as a SET will automatically use the DSET backup type.
Select BWAV, RADAR, BOTH or DSET at the BACKUP TYPE: prompt and press .
Select ALL or MARK IN/OUT. If MARK IN/OUT is selected, this will apply to all projects.
To Next Page
Loading...
