www.izcorp.com • 1.800.776.1356
At the FILE FORMAT: dialogue, use the and keys to select WAV, BWAV or CDAUDIO
and press the key.
If always using WAV or BWAV when exporting, the FILE FORMAT preference can be set to
avoid this prompt each time an export is done.
To set the FILE FORMAT preference:
a. Use the , the and keys and the key to go to the MAIN MENU /
FILE MENU / FILE PREFS / EXPORT FORMAT selection and press the key.
b. At the FILE FORMAT: prompt, use the and keys to select WAV or BWAV and then
press the key. The factory default setting is ASK.
At the EXPORT TO: dialogue, use the and keys to select the device to export to and
press the key. This list will include D:ARCHIVE (RADAR internal system drive partition),
N: (network shares), B: (DVD-RAM, DVD-R, BD-RE or CD-R) and any FAT32 or HFS Standard
formatted SCSI drives connected to the RADAR SCSI bus.
If selecting B:DVD BLANK DISK, proceed to step 5.
Use one of the following methods to select a destination folder in the SELECT FOLDER:
dialogue:
a. Use the and keys to select an existing folder name and press the key.
b. Select NEW FOLDER and press the key to create a new one. At the FOLDER
NAME dialogue type in a name for the folder and press the key. The menu will return
to the SELECT FOLDER dialogue with the new folder name as the current selection. Press
the key to accept this folder as a destination.
Select a FILL SILENCE option. FILL SILENCE is a method that allows a track with gaps (blank
spaces between recorded sections) to be exported as a single file. This is accomplished by filling
the gaps with zero data thus creating a file that spans the length of the current project. This
increases conversion and transfer time but it reduces effort when the files are imported in a DAW
application as there will only be one file per track to spot to a start time. Most workstations have a
strip silence option that can be used to remove any unwanted silence between recordings. If NO
is chosen for the FILL SILENCE option, the directory will contain the individual recording files
ordered by track and start time. Once the selection is made, press the key.
Turn the fill silence option on or off by setting the FILL SILENCE preference to YES or NO.
To Next Page
Loading...
