Keysight Technologies InfiniiVision DSOX1204A User Manual

136 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
6 Root (:) Commands
:AER (Arm Event Register)
(see page 798)
Query Syntax
:AER?
The AER query reads the Arm Event Register. After the Arm Event Register is read,
it is cleared. A "1" indicates the trigger system is in the armed state, ready to
accept a trigger.
The Armed Event Register is summarized in the Wait Trig bit of the Operation
Status Event Register. A Service Request can be generated when the Wait Trig bit
transitions and the appropriate enable bits have been set in the Operation Status
Enable Register (OPEE) and the Service Request Enable Register (SRE).
Return Format
<value><NL>
<value> ::= {0 | 1}; an integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 135
• ":OPEE (Operation Status Enable Register)" on page 148
• ":OPERegister:CONDition (Operation Status Condition Register)" on page 150
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 152
• "*STB (Read Status Byte)" on page 127
• "*SRE (Service Request Enable)" on page 125

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English