410 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
21 :MTESt Commands
:MTESt:COUNt:FWAVeforms
(see page 798)
Query Syntax
:MTESt:COUNt:FWAVeforms? [CHANnel<n>]
<n> ::= 1 to (# analog channels) in NR1 format
The :MTESt:COUNt:FWAVeforms? query returns the total number of failed
waveforms in the current mask test run. This count is for all regions and all
waveforms collected on the channel specified by the optional parameter or
collected on the currently specified source channel (:MTESt:SOURce) if there is no
parameter.
Return Format
<failed><NL>
<failed> ::= number of failed waveforms in NR1 format.
See Also • "Introduction to :MTESt Commands" on page 401
• ":MTESt:COUNt:WAVeforms" on page 413
• ":MTESt:COUNt:TIME" on page 412
• ":MTESt:COUNt:RESet" on page 411
• ":MTESt:SOURce" on page 431
Example Code • "Example Code" on page 401
To Next Page
Loading...
Need help?
General
