223
Keysight InfiniiVision DSOX1204A/G Oscilloscopes
Programmer's Guide
11 :DEMO Commands
When the education kit is licensed (Option EDK), you can output demonstration
signals on the oscilloscope's Demo terminal. See "Introduction to :DEMO
Commands" on page 223.
Introduction to
:DEMO Commands
The :DEMO subsystem provides commands to output demonstration signals on
the oscillosope's Demo terminal.
Reporting the Setup
Use :DEMO? to query setup information for the DEMO subsystem.
Return Format
The following is a sample response from the :DEMO? query. In this case, the query
was issued following the *RST command.
:DEMO:FUNC SIN;OUTP 0
Table 56 :DEMO Commands Summary
Command Query Options and Query Returns
:DEMO:FUNCtion
<signal> (see
page 224)
:DEMO:FUNCtion? (see
page 225)
<signal> ::= {SINusoid | NOISy |
LFSine | AM | RFBurst | FMBurst |
HARMonics | COUPling | RINGing |
SINGle | CLK | TRANsition | BURSt
| GLITch | UART | CAN | LIN}
:DEMO:OUTPut {{0 |
OFF} | {1 | ON}} (see
page 226)
:DEMO:OUTPut? (see
page 226)
{0 | 1}
To Next Page
Loading...
Need help?
General
