To Next Page

To Previous Page

328 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide

19 :MARKer Commands

:MARKer:MODE

(see page 798)

Command Syntax

:MARKer:MODE <mode>

<mode> ::= {OFF | MEASurement | MANual | WAVeform}

The :MARKer:MODE command sets the cursors mode:

• OFF — removes the cursor information from the display.

• MANual — enables manual placement of the X and Y cursors.

If the front-panel cursors are off, or are set to the front-panel Hex or Binary

mode, setting :MARKer:MODE MANual will put the cursors in the front-panel

Normal mode.

• MEASurement — cursors track the most recent measurement.

Setting the mode to MEASurement sets the marker sources

(:MARKer:X1Y1source and :MARKer:X2Y2source) to the measurement source

(:MEASure:SOURce). Setting the measurement source remotely always sets the

marker sources.

• WAVeform — the Y1 cursor tracks the voltage value at the X1 cursor of the

waveform specified by the X1Y1source, and the Y2 cursor does the same for the

X2 cursor and its X2Y2source.

Query Syntax

:MARKer:MODE?

The :MARKer:MODE? query returns the current cursors mode.

Return Format

<mode> ::= {OFF | MEAS | MAN | WAV}

See Also • "Introduction to :MARKer Commands" on page 326

• ":MARKer:X1Y1source" on page 330

• ":MARKer:X2Y2source" on page 332

• ":MEASure:SOURce" on page 380

• ":MARKer:X1Position" on page 329

• ":MARKer:X2Position" on page 331

• ":MARKer:Y1Position" on page 336

• ":MARKer:Y2Position" on page 337

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: