Keysight Technologies InfiniiVision DSOX1204A User Manual

:MARKer Commands 19
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 335
:MARKer:XUNits:USE
(see page 798)
Command Syntax
:MARKer:XUNits:USE
When DEGRees is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 degrees and the current X2 location as
360 degrees.
When PERCent is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 percent and the current X2 location as
100 percent.
Once the 0 and 360 degree or 0 and 100 percent locations are set, inputs to and
outputs from the :MARKer:X1Position, :MARKer:X2Position, and :MARKer:XDELta
commands/queries are relative to the set locations.
See Also • "Introduction to :MARKer Commands" on page 326
• ":MARKer:XUNits" on page 334
• ":MARKer:X1Y1source" on page 330
• ":MARKer:X2Y2source" on page 332
• ":MEASure:SOURce" on page 380
• ":MARKer:X1Position" on page 329
• ":MARKer:X2Position" on page 331
• ":MARKer:XDELta" on page 333

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English