Keysight Technologies InfiniiVision DSOX1204A User Manual

Obsolete and Discontinued Commands 31
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 741
:MEASure:VDELta
(see page 798)
Query Syntax
:MEASure:VDELta?
The :MEASure:VDELta? query returns the voltage difference between vertical
marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No measurement is made
when the :MEASure:VDELta? query is received by the oscilloscope. The delta value
that is returned is the current value. This is the same value as the front-panel
cursors delta Y value.
VDELta = value at marker 2 - value at marker 1
Return Format
<value><NL>
<value> ::= delta V value in NR1 format
See Also • "Introduction to :MARKer Commands" on page 326
• "Introduction to :MEASure Commands" on page 350
• ":MARKer:Y1Position" on page 336
• ":MARKer:Y2Position" on page 337
• ":MARKer:YDELta" on page 338
• ":MEASure:TDELta" on page 733
• ":MEASure:TSTArt" on page 737
NOTE
The :MEASure:VDELta command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:YDELta command (see page 338) instead.

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English