:CALibrate Commands 9
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 197
:CALibrate:STARt
(see page 798)
Command Syntax
:CALibrate:STARt
The CALibrate:STARt command starts the user calibration procedure.
See Also • "Introduction to :CALibrate Commands" on page 192
• ":CALibrate:PROTected" on page 196
Before starting the user calibration procedure, you must set the rear panel CALIBRATION
switch to UNPROTECTED, and you must connect BNC cables from the TRIG OUT connector to
the analog channel inputs. See the User's Guide for details.