765
Keysight InfiniiVision DSOX1204A/G Oscilloscopes
Programmer's Guide
33 Status Reporting
Status Reporting Data Structures / 767
Status Byte Register (STB) / 770
Service Request Enable Register (SRE) / 772
Trigger Event Register (TER) / 773
Output Queue / 774
Message Queue / 775
(Standard) Event Status Register (ESR) / 776
(Standard) Event Status Enable Register (ESE) / 777
Error Queue / 778
Operation Status Event Register (:OPERegister[:EVENt]) / 779
Operation Status Condition Register (:OPERegister:CONDition) / 780
Arm Event Register (AER) / 781
Overload Event Register (:OVLRegister) / 782
Mask Test Event Event Register (:MTERegister[:EVENt]) / 783
Clearing Registers and Queues / 784
Status Reporting Decision Chart / 785
IEEE 488.2 defines data structures, commands, and common bit definitions for
status reporting (for example, the Status Byte Register and the Standard Event
Status Register). There are also instrument-defined structures and bits (for
example, the Operation Status Event Register and the Overload Event Register).
An overview of the oscilloscope's status reporting structure is shown in the
following block diagram. The status reporting structure allows monitoring
specified events in the oscilloscope. The ability to monitor and report these events
allows determination of such things as the status of an operation, the availability
and reliability of the measured data, and more.
To Next Page
Loading...
Need help?
General
