:DISPlay Commands 12
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 233
:DISPlay:CLEar
(see page 798)
Command Syntax
:DISPlay:CLEar
The :DISPlay:CLEar command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data is
erased. If the oscilloscope is running, all of the data for active channels and
functions is erased; however, new data is displayed on the next acquisition.
See Also • "Introduction to :DISPlay Commands" on page 228