516 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:SPI:SOURce:MOSI
(see page 798)
Command Syntax
:SBUS<n>:SPI:SOURce:MOSI <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:SPI:SOURce:MOSI command sets the source for the SPI serial
MOSI data.
You can also use the equivalent :SBUS<n>:SPI:SOURce:DATA command to set the
MOSI data source.
Query Syntax
:SBUS<n>:SPI:SOURce:MOSI?
The :SBUS<n>:SPI:SOURce:MOSI? query returns the current source for the SPI
serial MOSI data.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:SPI:SOURce:MISO" on page 515
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 513
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 514
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA" on page 517
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA" on page 519
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh" on page 518
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh" on page 520
To Next Page
Loading...
Need help?
General
