To Next Page

To Previous Page

Obsolete and Discontinued Commands 31

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 737

:MEASure:TSTArt

(see page 798)

Command Syntax

:MEASure:TSTArt <value> [suffix]

<value> ::= time at the start marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTArt command moves the start marker (X1 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTArt?

The :MEASure:TSTArt? query returns the time at the start marker (X1 cursor).

Return Format

<value> ::= time at the start marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 326

• "Introduction to :MEASure Commands" on page 350

• ":MARKer:X1Position" on page 329

• ":MARKer:X2Position" on page 331

• ":MARKer:XDELta" on page 333

• ":MEASure:TDELta" on page 733

• ":MEASure:TSTOp" on page 738

NOTE

The short form of this command, TSTA, does not follow the defined Long Form to Short Form

Truncation Rules (see page 800). The normal short form "TST" would be the same for both

TSTArt and TSTOp, so sending TST for the TSTArt command produces an error.

NOTE

The :MEASure:TSTArt command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X1Position command (see page 329) instead.

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: