Keysight Technologies InfiniiVision DSOX1204A User Manual

576 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
26 :TIMebase Commands
:TIMebase:POSition
(see page 798)
Command Syntax
:TIMebase:POSition <pos>
<pos> ::= time in seconds from the trigger to the display reference
in NR3 format
The :TIMebase:POSition command sets the time interval between the trigger event
and the display reference point on the screen. The display reference point is either
left, right, or center and is set with the :TIMebase:REFerence command. The
maximum position value depends on the time/division settings.
Query Syntax
:TIMebase:POSition?
The :TIMebase:POSition? query returns the current time from the trigger to the
display reference in seconds.
Return Format
<pos><NL>
<pos> ::= time in seconds from the trigger to the display reference
in NR3 format
See Also • "Introduction to :TIMebase Commands" on page 574
• ":TIMebase:REFerence" on page 578
• ":TIMebase:RANGe" on page 577
• ":TIMebase:SCALe" on page 579
• ":TIMebase:WINDow:POSition" on page 581
• ":TIMebase:DELay" on page 755
NOTE
This command is an alias for the :TIMebase:DELay command.

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English