To Next Page

To Previous Page

:MARKer Commands 19

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 339

:MARKer:YUNits

(see page 798)

Command Syntax

:MARKer:YUNits <units>

<units> ::= {BASE | PERCent}

The :MARKer:YUNits command sets the Y cursors units:

• BASE — for making measurements in the units associated with the cursors

source.

• PERCent — for making ratio measurements. Use the :MARKer:YUNits:USE

command to set the current Y1 location as 0 percent and the current Y2

location as 100 percent.

Changing Y units affects the input and output values of the :MARKer:Y1Position,

:MARKer:Y2Position, and :MARKer:YDELta commands/queries.

Query Syntax

:MARKer:YUNits?

The :MARKer:YUNits? query returns the current Y cursors units.

Return Format

<units> ::= {BASE | PERC}

See Also • "Introduction to :MARKer Commands" on page 326

• ":MARKer:YUNits:USE" on page 340

• ":MARKer:X1Y1source" on page 330

• ":MARKer:X2Y2source" on page 332

• ":MEASure:SOURce" on page 380

• ":MARKer:Y1Position" on page 336

• ":MARKer:Y2Position" on page 337

• ":MARKer:YDELta" on page 338

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: