Keysight Technologies InfiniiVision DSOX1204A User Manual

:WGEN Commands 29
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 679
:WGEN:MODulation:AM:DEPTh
(see page 798)
Command Syntax
:WGEN:MODulation:AM:DEPTh <percent>
<percent> ::= AM depth percentage from 0% to 100% in NR1 format
The :WGEN:MODulation:AM:DEPTh command specifies the amount of amplitude
modulation.
AM Depth refers to the portion of the amplitude range that will be used by the
modulation. For example, a depth setting of 80% causes the output amplitude to
vary from 10% to 90% (90% – 10% = 80%) of the original amplitude as the
modulating signal goes from its minimum to maximum amplitude.
Query Syntax
:WGEN:MODulation:AM:DEPTh?
The :WGEN:MODulation:AM:DEPTh? query returns the AM depth percentage
setting.
Return Format
<percent><NL>
<percent> ::= AM depth percentage from 0% to 100% in NR1 format
See Also • ":WGEN:MODulation:AM:FREQuency" on page 680
• ":WGEN:MODulation:FM:DEViation" on page 681
• ":WGEN:MODulation:FM:FREQuency" on page 682
• ":WGEN:MODulation:FSKey:FREQuency" on page 683
• ":WGEN:MODulation:FSKey:RATE" on page 684
• ":WGEN:MODulation:FUNCtion" on page 685
• ":WGEN:MODulation:FUNCtion:RAMP:SYMMetry" on page 686
• ":WGEN:MODulation:STATe" on page 688
• ":WGEN:MODulation:TYPE" on page 689

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English