To Next Page

To Previous Page

738 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide

31 Obsolete and Discontinued Commands

:MEASure:TSTOp

(see page 798)

Command Syntax

:MEASure:TSTOp <value> [suffix]

<value> ::= time at the stop marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTOp command moves the stop marker (X2 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTOp?

The :MEASure:TSTOp? query returns the time at the stop marker (X2 cursor).

Return Format

<value> ::= time at the stop marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 326

• "Introduction to :MEASure Commands" on page 350

• ":MARKer:X1Position" on page 329

• ":MARKer:X2Position" on page 331

• ":MARKer:XDELta" on page 333

• ":MEASure:TDELta" on page 733

• ":MEASure:TSTArt" on page 737

NOTE

The short form of this command, TSTO, does not follow the defined Long Form to Short Form

Truncation Rules (see page 800). The normal short form "TST" would be the same for both

TSTArt and TSTOp, so sending TST for the TSTOp command produces an error.

NOTE

The :MEASure:TSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X2Position command (see page 331) instead.

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: