To Next Page

To Previous Page

:TRIGger Commands 27

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 599

:TRIGger[:EDGE]:LEVel

(see page 798)

Command Syntax

:TRIGger[:EDGE]:LEVel <level>

<level> ::= <level>[,<source>]

<level> ::= 0.75 x full-scale voltage from center screen in NR3 format

for internal triggers

<level> ::= ±(external range setting) in NR3 format

for external triggers

<source> ::= {CHANnel<n> | EXTernal}

<n> ::= 1 to (# analog channels) in NR1 format

The :TRIGger[:EDGE]:LEVel command sets the trigger level voltage for the active

trigger source.

Query Syntax

:TRIGger[:EDGE]:LEVel? [<source>]

The :TRIGger[:EDGE]:LEVel? query returns the trigger level of the current trigger

source.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 585

• ":TRIGger[:EDGE]:SOURce" on page 602

• ":EXTernal:RANGe" on page 257

NOTE

If the optional source is specified and is not the active source, the level on the active source is

not affected and the active source is not changed.

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: