To Next Page

To Previous Page

:SBUS<n> Commands 24

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 475

:SBUS<n>:CAN:SIGNal:DEFinition

(see page 798)

Command Syntax

:SBUS<n>:CAN:SIGNal:DEFinition <value>

<value> ::= {CANH | CANL | RX | TX | DIFFerential | DIFL | DIFH}

The :SBUS<n>:CAN:SIGNal:DEFinition command sets the CAN signal type when

:SBUS<n>:CAN:TRIGger is set to SOF (start of frame). These signals can be set to:

Dominant high signals:

• CANH — the actual CAN_H differential bus signal.

• DIFH — the CAN differential (H-L) bus signal connected to an analog source

channel using a differential probe.

Dominant low signals:

• CANL — the actual CAN_L differential bus signal.

• RX — the Receive signal from the CAN bus transceiver.

• TX — the Transmit signal to the CAN bus transceiver.

• DIFL — the CAN differential (L-H) bus signal connected to an analog source

channel using a differential probe.

• DIFFerential — the CAN differential bus signal connected to an analog source

channel using a differential probe. This is the same as DIFL.

Query Syntax

:SBUS<n>:CAN:SIGNal:DEFinition?

The :SBUS<n>:CAN:SIGNal:DEFinition? query returns the current CAN signal type.

Return Format

<value> ::= {CANH | CANL | RX | TX | DIFL | DIFH}

See Also • "Introduction to :TRIGger Commands" on page 585

• ":SBUS<n>:MODE" on page 465

• ":SBUS<n>:CAN:SIGNal:BAUDrate" on page 474

• ":SBUS<n>:CAN:SOURce" on page 476

• ":SBUS<n>:CAN:TRIGger" on page 477

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: