To Next Page

To Previous Page

308 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide

17 :FUNCtion Commands

:FUNCtion:SOURce1

(see page 798)

Command Syntax

:FUNCtion:SOURce1 <value>

<value> ::= {CHANnel<n> | GOFT}

<n> ::= 1 to (# analog channels) in NR1 format

The :FUNCtion:SOURce1 command is used for any :FUNCtion:OPERation selection

(including the ADD, SUBTract, or MULTiply channel math operations and the FFT

transform). This command selects the first source for channel math operations or

the single source for the transforms.

The GOFT parameter is only available for the FFT function. It lets you specify, as

the function input source, the addition, subtraction, or multiplication of two

channels. When GOFT is used, the g(t) source is specified by the

:FUNCtion:GOFT:OPERation, :FUNCtion:GOFT:SOURce1, and

:FUNCtion:GOFT:SOURce2 commands.

Query Syntax

:FUNCtion:SOURce1?

The :FUNCtion:SOURce1? query returns the current source1 for function

operations.

Return Format

<value> ::= {CHAN<n> | GOFT}

<n> ::= 1 to (# analog channels) in NR1 format

See Also • "Introduction to :FUNCtion Commands" on page 291

• ":FUNCtion:OPERation" on page 303

• ":FUNCtion:GOFT:OPERation" on page 299

• ":FUNCtion:GOFT:SOURce1" on page 300

• ":FUNCtion:GOFT:SOURce2" on page 301

NOTE

Another shorthand notation for SOURce1 in this command/query (besides SOUR1) is SOUR.

Keysight Technologies InfiniiVision DSOX1204A User Manual

Questions and Answers: