:FRANalysis Commands 16
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 277
:FRANalysis:FREQuency:MODE
(see page 798)
Command Syntax
:FRANalysis:FREQuency:MODE <setting>
<setting> ::= {SWEep | SINGle}
The :FRANalysis:FREQuency:MODE command lets you select between the normal
swept frequency response analysis or analysis at a single frequency, which can be
useful when debugging.
Query Syntax
:FRANalysis:FREQuency:MODE?
The :FRANalysis:FREQuency:MODE? query returns the frequency mode setting.
Return Format
<setting><NL>
<setting> ::= {SWEep | SINGle}
See Also • ":FRANalysis:RUN" on page 281
• ":FRANalysis:FREQuency:SINGle" on page 278
• ":FRANalysis:FREQuency:STARt" on page 279
• ":FRANalysis:FREQuency:STOP" on page 280
• ":FRANalysis:SWEep:POINts" on page 284
The SINGle mode is available through the remote programming interface only and is not
available when using the front panel graphical user interface (GUI).
To Next Page
Loading...
Need help?
General
