Keysight Technologies InfiniiVision DSOX1204A User Manual

704 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
30 :WMEMory<r> Commands
:WMEMory<r>:DISPlay
(see page 798)
Command Syntax
:WMEMory<r>:DISPlay <on_off>
<r> ::= 1-2 in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :WMEMory<r>:DISPlay command turns the display of the specified reference
waveform on or off.
There are two reference waveform locations, but only one reference waveform can
be displayed at a time. That means, if :WMEMory1:DISPlay is ON, sending the
:WMEMory2:DISPlay ON command will automatically set :WMEMory1:DISPlay
OFF.
Query Syntax
:WMEMory<r>:DISPlay?
The :WMEMory<r>:DISPlay? query returns the current display setting for the
reference waveform.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • Chapter 30, “:WMEMory<r> Commands,” starting on page 701
• ":WMEMory<r>:CLEar" on page 703
• ":WMEMory<r>:LABel" on page 705

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English