Keysight Technologies InfiniiVision DSOX1204A User Manual

312 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
18 :HARDcopy Commands
Introduction to
:HARDcopy
Commands
The HARDcopy subsystem provides commands to set and query the selection of
hardcopy device and formatting options such as inclusion of instrument settings
(FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this case, the
query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
:HARDcopy:NETWork:SLO
T <slot> (see
page 321)
:HARDcopy:NETWork:SLO
T? (see page 321)
<slot> ::= {NET0 | NET1}
:HARDcopy:PALette
<palette> (see
page 322)
:HARDcopy:PALette?
(see page 322)
<palette> ::= {COLor | GRAYscale
| NONE}
n/a :HARDcopy:PRINter:LIS
T? (see page 323)
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
:HARDcopy:STARt (see
page 324)
n/a n/a
Table 63 :HARDcopy Commands Summary (continued)
Command Query Options and Query Returns

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English