34 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
2 Setting Up
If automatic configuration is not supported, get the oscilloscope's network
parameters (hostname, domain, IP address, subnet mask, gateway IP, DNS IP,
etc.).
3 Connect the oscilloscope to the local area network (LAN) by inserting LAN
cable into the "LAN" port on the back of the oscilloscope.
4 Configure the oscilloscope's LAN interface:
a Press the Configure softkey until "LAN" is selected.
b Press the LAN Settings softkey.
c Press the Config softkey, and enable all the configuration options supported
by your network.
d If automatic configuration is not supported, press the Addresses softkey.
Use the Modify softkey (and the other softkeys and the Entry knob) to enter
the IP Address, Subnet Mask, Gateway IP, and DNS IP values.
When you are done, press the [Back up] key.
e Press the Host name softkey. Use the softkeys and the Entry knob to enter the
Host name.
When you are done, press the [Back up] key.
To Next Page
Loading...
Need help?
General
