478 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors • "-241, Hardware missing" on page 759
See Also • "Introduction to :SBUS<n> Commands" on page 461
• ":SBUS<n>:MODE" on page 465
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA" on page 479
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth" on page 480
• ":SBUS<n>:CAN:TRIGger:PATTern:ID" on page 481
• ":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE" on page 482
• ":SBUS<n>:CAN:SIGNal:DEFinition" on page 475
• ":SBUS<n>:CAN:SOURce" on page 476
To Next Page
Loading...
Need help?
General
