Leibinger JET3 - Printgo-Distance

Group 8 Job editor Page 170
Release R1.03e LEIBINGER JET3
8.5.1.2 PrintGo-distance
The setting defines the distance by the set value between the several text outputs.
The input happens in the measurement which has been selected in the basic
settings.
The set value is shown on the accordant display field.
As higher the entered value, as higher is the distance between the single prints.
Figure 104
PrintGo-distance
Attention! If the Print-Go distance has been selected too small, Print-
Go errors can be caused, because a print has been not printed
completely during a new print should be already started!
Example of error:
text
(
p
rint)
PrintGo -
distance
text
(
p
rint)
Print-Go distance
too small
Print-Go distance
correct