Leibinger JET3 - Page 80

Group 7 Data/Programming Page 80
Release R1.03e LEIBINGER JET3
Proceeding:
 Press on the register card <Interval> (2) to select the functional area.
 Now mark in the setting field <Interval On> (3) the hour-
or minute block to
change the values.
 With the the two <Arrow buttons> (6) you can increase or reduce the blocks
wich are each marked.
 Now carry out the settings in the field <Interval (Off> (4) accordingly.
 Now activate if necessary
the viscosity control by clicking on the control box
(7). An activated control is displayed by a √
in the control box.