Group 7 Data/Programming Page 93
Release R1.03e LEIBINGER JET3
By pressing the direct button [icon] <Service>
(1) or with the options
<Printhead> (3) or <Hydraulic>
(4) you can open the menu „Hydraulic/Printhead
Test“ (5).
This menu provides the verification of hydraulic components, activation or
deactivation and setting of print head functions as well as the processing of special
functions. All changes have only a temporary effect, that means as long as the
menu is open.
The selection of a functional area happens by clicking on the accordant register card
(8).
Note:
The proceeding corresponds to the Windows™-standard procedure.
By pressing the button <Emergency off>
(6) the JET3 is turned off immediately,
without carrying out further actions (e.g. closing the nozzle).
The button <Close> (5) closes the menu.
By closing the menu all changes are reset to the normal/fully
automatic operating condition!
If the menu closes an accordant message (9) is faded in which can
confirm or cancel the quitting.
To Next Page
Loading...
