Tray 2 or tray 3 empty service check
Action Yes No
Step 1
a Add media on the paper tray.
b Properly set the paper restraints on the paper tray.
c POR the printer.
d Reseat the input option tray from the printer.
e Refer to the media specifications and check the condition of the media.
f Make sure the media is free from damage and defects.
Does the error remain?
Go to step 2. Problem resolved.
Step 2
Is the machine using both 650 and 550 input option tray?
Go to step 3. Go to step 4.
Step 3
a Make sure the sequence of the input option trays is correct. The 650
option tray should be in tray 2, and the 550 option tray should be in
tray 3.
b Bring the printer into the Diagnostics Menu.
c Navigate to Feed Test > Tray # > Single Feed Test.
d Run a continuous feed test (feed at least 5 pages).
Does the feed test run successfully on each option?
Go to step 8. Go to step 4.
Step 4
Isolate the problem. Verify the problem by installing only one input option
to the printer at a time.
a Bring the printer into the Diagnostics Menu.
b Navigate to Feed Test > Tray # > Single Feed Test.
Does the feed test run successfully on each option?
Go to step 8. Go to step 5.
5027
Diagnostic information
157
To Next Page
Loading...
