EasyManuals Logo

Lexmark CS310 User Manual

Lexmark CS310
377 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Operator panel (display blank) service check
Replace one of the following components, and perform a POR before replacing a second component. Never replace
both of the components without performing a POR after installing each one, or the printer will be rendered inoperable.
For CS310 models:
• Controller board
• Operator panel with UICC card
For CS410 and CS510 models:
• Controller board
• UICC card
Warning—Potential Damage: Never install and remove components listed above as a method of troubleshooting
components. Once a component has been installed in a printer, and the printer is powered on, it cannot be used in
another printer. It must be returned to the manufacturer.
Note: The printer has detected a problem with the controller board, the operator panel assembly cable (part of the
front cover assembly), or the operator panel assembly if POST does not complete. The printer emits five beeps, and
sticks in a continuous pattern until the printer is turned off.
For CS310 models:
5027
Diagnostic information
131

Table of Contents

Other manuals for Lexmark CS310

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark CS310 and is the answer not in the manual?

Lexmark CS310 Specifications

General IconGeneral
Print TechnologyColor Laser
Print Resolution1200 x 1200 dpi
Monthly Duty CycleUp to 60, 000 pages
Standard Memory256 MB
Processor Speed800 MHz
Standard Input Capacity250 sheets
ConnectivityUSB 2.0, Ethernet
Standard Output Capacity125 sheets
Recommended Monthly Page Volume500 - 3, 000 pages
Operating Systems SupportedWindows, Linux

Related product manuals