Message Action
Too many flash options installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to properly grounded electrical
outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical
outlet.
5 Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control panel, select Continue to
continue printing. For non‑touch‑screen printer models,
press OK to confirm.
• Format the flash memory.
Note: If the error message remains, then the flash memory
may be defective and need to be replaced.
Waste toner bottle nearly full [82.xy]
You may need to order a waste toner bottle. If necessary,
select Continue on the printer control panel to clear the
message and continue printing. For non‑touch‑screen printer
models, press OK to confirm.
Weblink server not set up. Contact system
administrator.
An error occurred on the SMTP server, or the SMTP server is
not configured properly.
From the printer control panel, touch Continue to clear the
message.
Note: If the message appears again, then contact your
system support person.
Printer hardware errors
• “110 errors” on page 82
• “121 errors” on page 84
• “126 errors” on page 90
• “133 errors” on page 90
• “141 errors” on page 93
• “147 errors” on page 95
• “171 errors” on page 97
• “Steps before starting the 9yy service checks” on page 98
• “900 errors” on page 100
• “91y errors” on page 106
5027
Diagnostic information
80
To Next Page
Loading...
Need help?
General
