Actions Yes No
Step 4
Turn the printer off, and remove the rear cover. See
“Rear cover removal”
on page 290.
Is the JSP1 cable connector properly connected to the controller board?
Go to step 5. Reseat the connector.
Step 5
Turn the printer on, and check the voltage at JSP1 pin 15.
Is the voltage approximately +5 V dc?
Replace the paper pick
motor drive assembly.
See
“Paper pick motor
drive assembly
standard tray
removal” on page
287.
Replace the controller
board. See
“Controller
board removal” on
page 291.
Understanding printer messages
• “Understanding the printer messages” on page 72
5027
Diagnostic information
71
To Next Page
Loading...
