Lexmark CS310 - Entering Recovery Mode; Accessing the Network SE Menu; Accessing the Service Engineer (SE) Menu

3 Turn on the printer.
4 Release the buttons after 10 seconds.
Entering recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC via USB.
1 Turn off the printer.
2 Press and hold the 7, 2, and 8 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1 Touch Select and Right.
2 Navigate to Networks/Ports > Standard Network > Std Network Setup.
3 Press and hold 6, 7, and 9 simultaneously.
Accessing the service engineer (SE) menu
From a Web browser on a host PC, add /se to the printer IP address.
5027
Service menus
195