Lexmark CS310 - Operator Panel Bezel Removal; Operator Panel Removal (for CS310 Models Only)

Operator panel bezel removal
1 Remove the operator panel logo plate. See “Operator panel logo plate removal” on page 262.
2 Use a flat‑head screwdriver to pry the bezel loose, and remove.
Operator panel removal (for CS310 models only)
Installation warning: Replace one of the following components, and perform a POR before replacing a second
component. Never replace both of the components without performing a POR after installing each one, or the
printer may be rendered inoperable:
• Operator panel assembly
• Controller board
Note: The UICC card is part of the operator panel.
1 Remove the operator panel bezel. See “Operator panel bezel removal” on page 254.
2 Open the front cover.
5027
Repair information
254