Message Action
Restore held jobs?
Try one or more of the following:
• Select Restore on the printer control panel to restore all
held jobs stored in the printer hard disk. For
non‑touch‑screen printer models, press OK to confirm.
• Select Do not restore if you do not want any print jobs to
be restored. For non‑touch‑screen printer models, press
OK to confirm.
SMTP server not set up. Contact system
administrator.
From the printer control panel, touch Continue to clear the
message.
Note: If the message appears again, then contact your
system support person
Some held jobs were not restored
From the printer control panel, select Continue to clear the
message. For non‑touch‑screen printer models, press OK to
confirm.
Note: Held jobs that are not restored remain in the printer
hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to
continue printing. For non‑touch‑screen printer models,
press OK to confirm.
• Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print
server. For more information, contact customer support.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the
message. For non‑touch‑screen printer models, press OK to
confirm.
Notes:
• The printer discards any data received through the USB
port.
• Make sure the USB Buffer menu is not set to Disabled.
Supply needed to complete job
Try one or more of the following:
• From the printer control panel, touch Prompt for supplies
to view all error messages that indicate what supplies are
needed to continue processing the current job. For
non‑touch‑screen printer models, press OK to clear the
message and continue printing.
1 Order the missing supply immediately.
2 Install the supply. For more information, see the
instruction sheet that came with the supply.
• Cancel the print job, then install the missing supply, and
then resent the print job.
5027
Diagnostic information
79