5
Service work
Safety information regarding servicing work
Safety information regarding servicing work
The industrial truck will only remain ready
for operation at all times if the servicing and
inspection tasks are performed at regular in-
tervals and in accordance with the information
in the operating instructions.
Maintenance work may be performed only by
competent persons. You can agree to have
this work performed on the basis of a service
contract concluded with your service partner.
Whenever servicing work is p
erformed, the
industrial truck must be par
ked on a level
surface and secured so that i
t cannot roll away.
The industrial truck must be switched off
completely, and the battery male connector
and switch key must be removed.
When working with the fork carriage and/or
lift mast raised, make sure they are secured
against accidental dropping.
Whenever work is carried o
ut at the front of the
industrial truck, the l
ift mast must be secured
to prevent it tilting ba
ckwards.
Do not make any modifications, in particular
attachments or conversions, to your industrial
truck without the manufacturer's approval.
Following all servicing work, a function check
and test run must be performed on the indus-
trial truck.
WARNING
Any side doors fitted could fall shut during servicing
work and trap personnel.
For this reason, both doors must be opened and
secured in place during servicing.
CAUTION
The industrial truck must always be properly label-
led.
Missing or damaged identification plates and/or ad-
hesive labels must be replaced. For the warehouse
or order number, please consult the spare parts
catalogue.
ENVIRONMENT NOTE
Observe informat
ion regarding the use of
consumables.
Service interva
ls
The specified service intervals are subject
to the operating conditions and application
conditions, as well as the consumables in use.
In certain circumstances, the service intervals
can be changed. In all cases, the "Regular
Service" must be performed once per year.
In the case of operation in extreme conditions
(e.g. heat, cold or dust), the service intervals
must be reduced.
Contact your s
ervice partner.
208 Operating Instructions – 3888011701 EN – 12/2017
To Next Page
Loading...
