Linde E35 - Operating Devices; Checking the Brake System for Correct Function

5
Service work
Operating devices
Operating devices
Checking the brake system for
correct function
DANGER
Risk of accident or death if the brake system is
faulty.
Your industrial truck must not be used under any
circumstances if the brake system is faulty.
If you notice any defects on the brake system,
please contact your service partner immediately.
e3871121a
Using the stop pedal to check the
hydraulic operating brake for correct
function
 While driving, take your foot off the acceler-
ator pedal and actuate the stop pedal.
The truck must immediately brake to a stand-
still when the stop pedal is actuated.
NOTE
To ensure maxim
um braking force when the
stop pedal is fu
lly actuated, there must be a
distance of at l
east 3 mm between the lower
edge of the st
op pedal and the rubber mat
on the bottom
plate. Contact your service
partner.
3
4
e3871494
1
2
Checkin
g the LBC (Linde Brake Control)
for correc
tfunction
 Release the accelerator pedal (2) or (4)
while the truck is in motion.
The accelerator pedal automatically returns
to the zero position and the LBC electronics
brake the truck.
232 Operating Instructions – 3888011701 EN – 12/2017