Linde E35 - Hydraulic System: Checking for Leak Tightness

5
Service work
Hydraulics
Hydraulic system:
Checking for leak tightness
 Switch off the truck.
e3871143
 Remove the bottom plate.
 Check the hydraulic pump, va
lves, hoses
and lines in the control com
partment for
leaks.
 Check the connections for leaks. Tighten
the connections as necessary.
1
e3881118a
The radiator (1) for the hydraulic oil is located
in the control compartment, on the right-hand
side of the truck above the control block.
 Check the radiator for hydraulic oil for leak
tightness.
 Check the lift cy
linders, tilt cylinders and
steering cylind
er for leaks.
 Replace leaking, worn or porous parts.
248 Operating Instructions – 3888011701 EN – 12/2017