6
Technical data
Vibration characteristics for body vibrations
NOTE
Lower or higher noise emission values may
occur when using industrial trucks, e.g. due to
the method of operation, ambient factors and
other sources of noise.
Vibration characteristics for body vibrations
The values were determined according to EN
13059 using trucks with standard equipment
according to the type sheet (driving over test
course with humps).
Specified vibration characteristic according
to EN 13059
Measured
vibration
characteristic
a
W,ZS
=
<0.5m/s
2
Specified vibration characteristic for hand-
arm vibrations
Vibration characte
ristic < 1.5 m/s
2
NOTE
The vibration characteristic for body vibrations
cannot be used to determine the actual vibra-
tion load during operation. This depends on
the application conditions (state of roadway,
method of operation etc.) and should there-
fore be determined on site where appropriate.
It is mandatory to specify the hand-arm vibrati-
ons even where the values do not indicate any
hazard, as in this case.
298 Operating Instructions – 3888011701 EN – 12/2017
To Next Page
Loading...
