Linde E35 - Transporting the Truck Using a Lorry or Flat-Bed Trailer

4
Operation
Loading / transporting
Transporting the truck using a lorry or flat-bed trailer
NOTE
• The driver is responsible for his means of
transport, the transportation safety device
and for the transportation of the truck
• Observe the national regulations for your
country
DANGER
Risk to life caused by overloading and material
damage!
 Only load the truck if the load capacity of the
means of transport, ramps and loading bridges
is greater than the total actual weight of the truck.
 Note the loading weight on the nameplate.
Loading
DANGER
Risk of accident from the truck crashing!
To prevent the truck from tipping over the edge
or corners, avoid steering movements on narrow
loading bridges/ramps.
Requirements for loading:
• The loading surface of the transport vehicle
must be dry and swept clean
• The tyres on the truck must be clean
 Before driving across a loa
ding bridge,
ensure that the loading bri
dge is properly
attached and secured.
 Ensure that the transport vehicle onto which
the truck is to be driven has been sufficiently
secured against moving.
 Drive slowly and carefully onto the transport
vehicle.
 Lower the lift mast and ti
lt the lift mast
forwards.
The fork arms must be resting fully on the
ground.
 Activate the manual parking brake.
 Switch off the truck.
 Push the emergency off switch.
 Remove the switch key.
 Place and secure wedge
s underneath the
wheels, or drive the tr
uck against a fixed
stop so that the truck f
aces the fixed stop.
202 Operating Instructions – 3888011701 EN – 12/2017