Operation
4
Operation
Access system connect: (LFM)
The access system connect: enables the truck
to be commissioned via the input unit (keypad
or transponder) and monitors operating
statuses and usage.
1
2
3
4
e3861551
Keypad input
The input device (1) is located in the armrest
console (3) and has a 12-digit keypad (2).
With the standard setting,
a5-digitPINis
allocated to the respectiv
e driver to ensure that
the truck can be operated on
ly by authorised
personnel. The truck can be
started only after
entering this PIN and poss
ibly a status code
(depending on the setting
).
NOTE
The fleet manager can extend the PIN from 5
to 8 digits. The fleet manager can also activate
a 1-digit status code (Pre-operational check).
This code indicates the status of the truck.
5
6
7
8
e3861552
Logging in and switching on the truck
Fold up the armrest support (4).
Press the
Reset
butto
n (8) (or any other
button) to acti
vate the input unit from
standby mode.
NOTE
If a number button is pressed to activate the
input unit, this number is registered as the first
digit of the PIN.
LED (5) and LED (6) flash green alternately.
NOTE
If there is no further input, the input unit returns
to standby mode after 60 seconds (factory
setting). The fleet manager can change the
delay time.
Operating Instructions – 3888011701 EN – 12/2017 107
To Next Page
Loading...
