Linde E35 - Adjusting the Seat Backrest

4
Operation
Driver's compartment
2
1
e3881123
Longitudinal adjustment
WARNING
There is a risk of crushing if the lever is grasped
fully.
Only grasp the lever by the trough provided for this
purpose.
 Pull the lever (1) upwards.
Choose the most comfortable position in rela-
tion to the steering wheel and the accelerator
pedals.
 Move the driver's seat forwards or back-
wards.
 Allow the lever (1) to snap into place.
Adjusting the seat backrest
 Push the lever (2) upwards and hold it in
place.
 Move the seat backrest forwards or back-
wards until a comfortable seat position for
the driver is found.
 Release the lever (2
).
4
3
e3881124
Setting the drive
r's weight
NOTE
The individual driver's weight must be set
when the driver's seat is under load.
 Check the weight ad
justment in the inspec-
tion window (4).
The correct driver's weight has been selected
when the arrow is in the middle of the inspec-
tion window (4).
If necessary, adjust the driver's weight.
 Pull out the lever (3)
.
Move the lever to set the driver's weight for the
suspension.
 Move the lever (3) upwards for a heavier
weight.
 Move the lever (3) dow
nwards for a lighter
weight.
58 Operating Instructions – 3888011701 EN – 12/2017