Linde E35 - Decommissioning; Shutting down the Industrial Truck; Recommissioning after Shutdown

5
Service work
Decommissioning
Decommissioning
Shutting down the industrial truck
Measures to be implemented before
shutdown
If the truck is to be shut down for a period
longer than 2 months, e.g. for operational
reasons, it must only be stored in a well-
ventilated, clean and dry room that is free
of frost. The following measures must be
implemented:
 Thoroughly clean the indu
strial truck.
 Raise the fork carriage several times to the
end stop.
 Tilt the lift mast forwards and backwards
repeatedly and actuate the attachment
repeatedly.
 Lower the fork carriage
to a supporting
surface until the chain
s are relieved of load.
 Check the hydraulic oil level and top up if
necessary.
 Coat all unpainted mechanical components
with a thin film of oil or grease.
 Grease vehicle.
 Disconnect the battery male connector.
 Check battery condition and density of acid.
 Lubricate battery t
erminals with acid-free
grease. (Follow the
battery manufacturer's
instructions.)
 Jack up the truck so that all wheels are off
the ground.
This will prevent permanent deformation of the
tyres.
NOTE
Do not cover with plastic film, as this will
encourage water condensation to form and
collect.
NOTE
If the truck is to be shut down for more than
six months, further measures must be agreed
with your authorised dealer.
Recommissioning after shutdown
 Thoroughly clean the industrial truck.
 Grease vehicle.
 Clean the battery and lubricate battery
terminals with acid-free grease
 Check battery condition and acid density;
recharge if necessary.
 Check hydraulic
oil for condensed water
and change if nec
essary.
 Perform maintenance as before initial
commissioning.
 Put the industrial truck into operation.
280 Operating Instructions – 3888011701 EN – 12/2017