5
Service work
Service plan
Additional servicing work every 3000 hours, but as a minimum every 3 years
(exceptions in brackets)
Gearbox
Check the mounting of the planetary transmission
(only once after 3000 hours).
Change the gearbox oil in the planetary transmission.
Check the bearings of the drive axle for wear.
Chassis, bodywork and fittings
Check the interlocks on the battery door and the battery hood and adjust as required.
Chassis frame
Check the mountings of the steering axle
Electrical enclosure
Check the condi
tion of the electric cables, connections and plug connectors, and check that they
are securely at
tached
Check that the electrical connections on the power modules and the electricmotorsaresecurely
attached.
Check the cables and plugs of the drive battery.
Calibrate the axle load sensor.
Calibrate the load pressure sensor.
Hydraulics
Change the breather filter, pressure filter and suction filter on the hydraulic system
Check the tilt-cylinder bearings for wear.
Load lift system
Check the condition of the lift mast, lift mast chain, lift cylinders and end stops and check that they
are securely attached and working correctly.
Check the fork arms and the fork arm locking devices.
Check the sideshift for wear.
Check the fork prong positioner for wear.
Additional servicing work every 6000 hours, but as a minimum every 6 years
Hydraulics
Replace the hydraulic oil in the hydraulic system
216 Operating Instructions – 3888011701 EN – 12/2017
To Next Page
Loading...
