Safety
2
Safety guidelines
DANGER
Any additional bores or welding on the overhead
guard will compromise its rigidity.
It is therefore strictly prohibited to drill holes in the
overhead guard or to perform welding work on it.
CAUTION
Risk of overloading the battery female connector.
This means that only the embedded battery female
connector (MRC socket) that has been approved
by the manufacturer may be used.
Make sure that the correct battery female connector
is connected, especially after changing the battery.
Contact your service partner.
CAUTION
Welding operatio
ns on other parts of the truck can
cause damage to t
he electronics.
Therefore, alwa
ys disconnect the battery and
all connection
s to the electronic controls before
performing any
welding work.
CAUTION
Various functions are supported by gas springs.
Gas springs are subjected to a high internal pres-
sure of up to 300 bar.
Gas springs may only be removed when they are
not under pressure, and must never be opened
without prior instruction. Any kind of damage,
lateral forces, buckling, temperatures in excess
of 80°C and heavy contamination must be avoided
under all circumstances.
Damaged or defective gas springs must be repla-
ced immediately.
Contact your service partner.
WARNING
In trucks with an accumulator, serious injuries may
occur if the accumulator is not handled properly.
Before starting work on the accumulator, it must be
depressurised.
Contact your service partner.
Operating Instructions – 3888011701 EN – 12/2017 13
To Next Page
Loading...
